hoover smartwash automatic carpet cleaner replacement parts

HOOVER SMARTWASH AUTOMATIC CARPET CLEANER REPLACEMENT PARTS MANUAL

Cleaner is not moving in forward direction

Refill container according to cleaning instructions,ġ.

Make sure tank is securely locked in position,.

Clean Water Tank or Solution Tank not firmly in placeĢ. If hose does not spray, prime the pump by lowering the hose down to the floor and hold the trigger for up to one minute.ġ.

Check for secure connection to solution port on body of Cleaner.Īccessory Tool will not spray after filling the Clean Water Tank or Solution Tank.

Turn off Cleaner and fill Clean Water Tank & Detergent Container.

Loose connection to solution port on foot of cleaner Clean Water Tank or Detergent Container is emptyĢ. Hose Nozzle stops spraying liquid during useġ.

Drop a coin through, clear with broom handle.

Remove and replace Dirty Water Nozzle, See “How to Clean & Remove Nozzle' page 15,.

Replace Dirty Water Tank and secure Dirty Water Tank latch.

Dirty Water Tank full/automatic shut off engagedĤ.

Slide Nozzle forward to snap into positionġ.

Position Nozzle onto foot, making sure to align the tabs at the top of the Nozzle with the notches inside the foot.

CAUTION, pull Nozzle carefully outwards and not upwards.

With handle in upright position, lift up on the Nozzle release then pull Nozzle forward to remove from carpet cleaner.

To prevent possible leaking, remove and empty Clean Water Tank, Dirty Water Tank and Solution Tank.

Empty tank, rinse, wipe filter clean and allow to air dry.

Place on a flat surface and unlatch Dirty Water Tank lid to remove top of tank.

Remove Tank from carpet cleaner base at an angle.

Grab the Dirty Water Tank handle and pull up to release.

Turn the cleaner off and unplug from electrical outlet.To rinse with clean water only, remove the Solution Tank and then repeat steps 4 through 6. This will remove residual carpet cleaning solution from your carpets. For best results, HOOVER® recommends rinsing the carpet with clean water only.Continue in this mode until little water is visibly passing through the Nozzle. The Dry Only mode will extract remaining water from your carpet. When you finish cleaning but further drying is required, press the DRY ONLY BUTTON.The cleaner will automatically dry your carpets by extracting the water and cleaning solution. The cleaner will automatically dispense the optimal amount of water and cleaning solution. Step on the Handle Release Pedal to recline the cleaner to cleaning position.Unwrap the power cord and plug cleaner in an electrical outlet.

Using Your SmartWash Pet Complete Carpet Cleaner

Place the Solution Tank back into the cleaner and press FIRMLY into place.

Remove the cap and fill with HOOVER Cleaning Solution to the top of the tank.

Remove the solution tank from the back of the cleaner.

Align Clean Water Tank with the body of the cleaner and press FIRMLY into place.

Remove the cap and add warm water to the top of tank.

Wrap the power cord around the cord hooks for convenient storage.

Slide the handle into the base until you hear a 'click'.

Getting Started With Your SmartWash Carpet Cleaner ASSEMBLY

Triggerless Handle Design & Removable Spot Chaser Pretreat Wand.

HOOVER SMARTWASH AUTOMATIC CARPET CLEANER REPLACEMENT PARTS MANUAL

USER MANUAL Carpet Cleaner What's in the Box? Getting to Know Your HOOVER' SmartWash Pet Complete Using Your SmartWash Pet Complete Carpet Cleaner.Getting Started With Your SmartWash Carpet Cleaner.Getting to Know Your HOOVER' SmartWash Pet Complete.

Owner's manual - (English, French, Spanish).

Hoover FH53000 SmartWash Pet Complete Automatic Carpet Cleaner - Use Manual - Use Guide PDF.

Hoover smartwash automatic carpet cleaner replacement parts